by admin

Ubuntu Can0 Device Id

Ubuntu Can0 Device Id

. Ubuntu 14.04 or newer. Debian 8 (Jessie) or newer If the driver is correctly loaded, CAN interface should be seen when issuing the command sudo ip link. Set can0 interface speed to 125 Kbps: sudo ip link set can0 up type can bitrate 125000 sample-point 0.875 Set to can0 to “steady” state (steady green led): sudo ip link set can0 up.

Cannot Find Device 'can0'

I'd like to retrieve a CAN trace without resorting to a Windows virtual machine — since this is how I do so far with the Windows-only PCAN-View and it's boring me.

This article explains how to enable the CAN bus on ODROID-C1/C1+/ via HW SPI interface. Detailed instruction to exchange data with a MCP2515 Bus Monitor board is also documented. H/W connectionThe following products are required to configure the hardware:.CAN Bus - Figure 1Figure 2 - ODROID Tinkering kitFigure 3 - Reference circuitFigure 4 - Breadboard diagramFigure 5 - Breadboard illustrationFigure 6 - Connect the CAN module and ODROID-C1 using tinkering kitBefore installing the software, you must modify the mcp2515 driver to set the amlogic GPIO IRQ.

Apply to your kernel. Unzip the zip file and type “git apply odroid-c1-mcp251x.patch”. Then, edit arch/arm/boot/dts/meson8bodroidc.dts and uncomment the can0 section.

Malayalam bgm ringtones download. Enable the CAN controller kernel driverODROID-C1 platform with a MCP2515 chip the configuration is: Linux Kernel Configuration Networking support CAN bus subsystem support CAN device drivers Platform CAN drivers with Netlink support CAN bit-timing calculation Microchip MCP251x SPI CAN controllerThen, reflash the kernel and root file system. See these instructions for how to build and install the kernel.